Liquid Penetrant Examination
| Customer | Customer Order No | ||
|---|---|---|---|
| Customer reference | - | Test site | - |
Object
| Drawing no | - | Manufacturing no | - |
|---|---|---|---|
| Base material | - | Filler material | - |
| Welding method | - | Joint | ☐ BW Butt Welds (Stumfog) ☐ FW Fillet Welds (kälfog) ☐ Butt Welds & Fillet Welds ☐ - |
| Heat treated | No |
Examination
| Extent | ☐ 100% ☐ 10% ☐ Spot check ☐ According to instructions | Method | Colour contrast penetrant |
|---|---|---|---|
| Examination acc. to | ☐ ISO 3452-1:2013 ☐ EN ISO 3452-1 | Acceptance acc. to | ☐ ISO 23277:2015-2X ☐ EN ISO 23277 ☐ ASME VIII div. 1 app. 8. |
| Specification no | - | Surface condition | ☐ Pickled ☐ Cleaned ☐ Uncleaned |
Penetrant system
| Cleaner (charge) | - | Penetrant (charge) | MR68NF |
|---|---|---|---|
| Remover charge no | - | Developer (charge) | MR 70 |
| Pre examination | Drying method: Air dry. Drying time: 5 min. | ||
|---|---|---|---|
| Application of penetrant | Application method: Brush. Penetration time: 20 min. Temp: 20 °C. | ||
| Removing | Penetrant removed with: Solvent. Drying method: Air dry. Drying time: 5 min. | ||
| Development | Method: Spray. Temp: 19 °C. | ||
Result
- Accepted (according to requirements)
- × Rejected
Brightness during the inspection was measured with a lux meter, Testo 540, acc. to EN ISO 3452-1 to an illuminance of .
Signatures
Performed by
Söderhamn,
__________________
UNSIGNED
Approved by — EN ISO 9712 Level 2 PT
Söderhamn,
__________________
UNSIGNED