Penetrant Protocol

Serial no

Customer

Customer order no

Customer reference

Project number

Test site

Object

Drawing no		Drawing revision
Base material		Filler material
Manufacturing no		Welding method
Joint type	☐BW Butt Welds (Stumfog)☐FW Fillet Welds (kälfog)☐Butt Welds & Fillet Welds☐-
Heat treated	☐ Yes	Sketch no

Examination

Extent	☐100%☐10%☐Spot check☐According to instructions
Supplementary data
Examination acc to	☐ISO 3452-1:2013☐EN ISO 3452-1
Acceptance acc to	☐ISO 23277:2015-2X☐EN ISO 23277☐ASME VIII div. 1 app. 8.
Specification no
Surface condition	☐Pickled☐Cleaned☐Uncleaned
Method	Colour contrast penetrant

Penetrant system

Standard procedure

Pre examination	Drying method: Air dry. Drying time: 5 min.
Application of penetrant	Application method: Brush. Penetration time: 20 min. Temp: 20 °C.
Removing	Penetrant removed with: Solvent. Drying method: Air dry. Drying time: 5 min.
Development	Method: Spray. Temp: 19 °C.

Result

According to requirements	☐ Yes	Sketch note

Brightness

Brightness during the inspection was measured with a lux meter, Testo 540, acc. to EN ISO 3452-1 to an illuminance of

Illuminance

Operator level

Signatures

Performed by

Söderhamn,

Signerare:

Välj signaturbild

Approved by

Söderhamn,

Signerare:

Välj signaturbild